Thermal Insulation Board Plaster

DEFINITION

Cement-based, fiber and polymer reinforced, high-performance thermal insulation board plaster.

• As plaster on polystyrene boards (XPS; Extruded Polystyrene or EPS; Expanded Polystyrene),
• For repair purposes; at the joints of main structural elements.
• Stone wool
• For corner and parapet cracks.
• For plastering purposes (up to 5 mm).
• On aerated concrete surfaces.
• As a thin plaster over rough plaster.

• Provides high adhesion to thermal insulation boards.
• Allows the system to breathe due to its vapor permeability.
• Provides easy and long-term working conditions.
• Provides a smooth and aesthetic appearance on interior and exterior surfaces.
• Absorbs small stresses.
• Minimizes crack formation with fiber and polymer reinforcement.

• Form: Cement-based, fiber and polymer-reinforced powder
• Color: Gray
• Packaging: 25 kg kraft bag
• Shelf Life: 12 months in a dry environment without moisture
• Unit Weight: 1300 ±100 g/lt
• Usable Time of the Mortar: 2 - 2.5 hours
• Working Time: 25 min
• Application Thickness: 3 - 5 mm

The panel to be applied must be properly adhered to the substrate.

Gaps between panels must be filled appropriately, and the surface must be smooth.

Pour 6-7 liters of water into a clean container large enough to hold one bag. Slowly add Allkim Flex Thermal Insulation Panel Mortar to the water and mix with a low-speed mixer until a homogeneous mixture is obtained. After the mixed mortar has rested for 5 minutes, it is mixed again for 1-2 minutes and made ready for use. The prepared mortar is applied to the thermal insulation boards with a thickness of 2 mm, and plaster mesh is laid to ensure adhesion to the surface. To prevent cracking, the reinforcement mesh should be applied overlapping by 10 cm at the joints. Then, a second coat of fine plaster is applied with a thickness of 2 mm. The material, which has started to harden, is smoothed and troweled.

Hand mixer, steel trowel, spatula, rubber trowel

1 year from the date of manufacture in dry and moisture-free conditions.

Depending on the surface to be applied and the thickness, 4-5 kg/m² for a thickness of 3-4 mm.

• The application temperature should be between +5 ⁰C and +35 ⁰C.
• Avoid application in very humid and very hot weather.
• Do not apply on surfaces where there is a risk of frost.
• After plaster application, the surface should be moistened at regular intervals.
• Coating, painting, and similar applications should begin 7 days after plaster application.
• Avoid prolonged contact of the material with eyes and skin, and do not inhale dust from the material.
• All tools used should be cleaned with water before they dry.
• The information provided is valid for application areas with a temperature of 23 ± 2 ⁰C and humidity of 50 ± 5%.

25 kg kraft bags (64 bags per pallet, 1600 kg)